Sharp MX-M850 - Manual (Page 312)

75
*1 Only effective when a finisher or saddle stitch finisher is installed.
*2 This setting is used to adjust the line width of vector graphics. Except for CAD and other specialized uses, there is
normally no need to change this setting. Information on the selections is shown in " Selections for the line thickness
setting " (Table below).
*3 Paper sizes that can be used with this function are 11" x 17", 8-1/2" x 14", 8-1/2" x 11", A3, B4, and A4. (This function
may not take effect with some print methods.)
*4 Only effective when printing PDF, JPEG, and TIFF files.
*5 Can only be selected when [1 Staple at Back] is selected.
*6 Only effective when a punch module is installed on a finisher or saddle stitch finisher.
*7 Can only be selected when a folding unit is installed.
Selections for the line thickness setting
* All lines are the minimum line width.
PCL SETTINGS
This is used to set the symbol sets, fonts, and line feed code used in a PCL environment.
Settings
POSTSCRIPT SETTING
When a PS (PostScript) error occurs during PostScript printing, this setting determines whether or not an error notice is
printed.
Selection 0 1 2 3 4 5 6 7 8 9
Percentage
Minimum
line width* 50% 75% 90% 95% 100% 105% 110% 125% 150%
Item Description Selections
PCL Symbol Set Setting
Specify the symbol set used for
printing. Select from 35 items.
PCL Font Setting
Use this to select the font used for
printing. • Internal Font
• Extended Font
(List of internal fonts when extended fonts are not
installed.)
PCL Line Feed Code
This setting is used to select how
the printer responds when a line
feed command is received. • 0.CR=CR; LF=LF; FF=FF
• 1.CR=CR+LF; LF=LF;FF=FF
• 2.CR=CR; LF=CR+LF; FF=CR+FF
• 3.CR=CR+LF; LF=CR+LF; FF=CR+FF
Wide A4
When this is enabled, 80
characters per line can be printed
on A4 size paper using a 10-pitch
font. (When this setting is
disabled, up to 78 characters can
be printed per line.) • (Enabled)
• (Disabled)
This setting can be configured when the PS3 expansion kit is installed.