Sharp MX-M850 - Manual (Page 66)

66
USING MANUAL FINISHING
The procedure for using manual finishing is explained below. Before beginning the procedure, configure the paper
settings in the system settings for the paper you will load in the inserter.
☞
PAPER TRAY SETTINGS (page 77)
1
Touch the [MANUAL FINISHING] key.
The base screen for manual finishing will appear.
2
Load the paper to be used for finishing
in the inserter.
For the procedure for loading paper on the paper tray, see
"
INSERTER " (page 62).
The orientation in which the paper is loaded on the tray will vary
depending on which manual finishing function is used. Make
sure you load the paper in the correct orientation for the
function you are using.
☞
PAPER LOADING ORIENTATION (FOR THE STAPLE
AND PUNCH FUNCTIONS)
(page 69)
☞
PAPER LOADING ORIENTATION (FOR FOLDING) (page 70)
3
Select the manual finishing function.
(1) Select the paper tray on which you loaded
paper.
(2) Select the function you wish to use.
(3) Select the output tray.
4
Press the [START] key ( )
Output takes place using the selected function.
When the staple or saddle stitch function is used, all sheets of paper loaded in the tray are stapled together as a single set.
To stop manual finishing...
Press the [STOP] key (
).
IMAGE SEND
DOCUMENT
FILING
COPY
Special Modes
Plain
2-Sided Copy
Output
File
Quick File
Ready to scan for copy.
Copy Ratio
0
1. 2.
7.
8½x11 8½x11
Original Paper Select
Auto
8½x11
Plain
Auto
8½x11
Exposure
Auto
8½x14 4.
11x17
11x17
6.
11x17
5.
11x17
3.
8½x11
100%
MANUAL
FINISHING
Plain
Plain
Fold
2 Hole
Punch
3 Hole
Punch
Offset Tray
Staple
Top Tray
Plain
8½x11
Plain
8½x11
Saddle
Stitch
Set the output function.
(1) (3) (2)