Press the [start] key ( ), 1) make sure that fax mode is selected, 1) touch the appropriate orientation key – Sharp MX-M850 User Manual
Page 378: 2) touch the [ok] key
58
3
Change to direct transmission mode and
display the original settings screen.
(1) Make sure that fax mode is selected.
If fax mode is not selected, touch the [Fax] tab.
(2) Touch the [Direct TX] key.
(3) Touch the [Original] key.
The current settings for [Original], [Exposure], and [Resolution] are indicated at the right of each key. To change a
setting, touch the appropriate key.
☞
AUTOMATICALLY SCANNING BOTH SIDES OF AN ORIGINAL (2-Sided Original)
ORIGINAL SCAN SIZE AND SEND SIZE (Enlarge/Reduce)
CHANGING THE EXPOSURE AND EXPOSURE
4
Specify the orientation in which the
original is placed.
When specifying the orientation of the image to be transmitted,
specify the orientation of the original placed in step 1.
(1) Touch the appropriate orientation key.
If the top edge of the original is up, touch the
key. If
the top edge of the original is to the left, touch the
key.
(2) Touch the [OK] key.
You will return to the screen of step 3.
The original orientation is initially set to
. If the original was placed with the top edge up, this step is not
necessary.
5
Press the [START] key (
).
Transmission begins.
If "Fax Dest. Confirmation Mode" is enabled in the system settings (administrator), a destination confirmation message
will appear. For more information, see "
FAX DESTINATION CONFIRMATION MODE
To cancel transmission...
While "Dialing. Press [
] to cancel" appears in the display, press the [STOP] key (
).
• The following functions cannot be used with direct transmission:
Program, Timer, 2in1, Card Shot, Job Build, Original Count, Polling Memory, File, Quick File, 2-Sided Original Scanning,
Global Address Search
• Resending will not take place when a direct transmission is not successful due to a communication error or other reason.
• If a fax transmission is already in progress when the direct transmission operation is performed, the direct transmission will wait until
the previous transmission is finished. When the previous transmission is completed, the direct transmission will begin. While the job is
waiting for transmission, you can press the [JOB STATUS] key to display the job status screen. No other operations can be performed.
☞
8. CHECKING THE STATUS OF TRANSMISSION/RECEPTION JOBS
(page 161)
• When transmission in direct transmission mode ends, the mode automatically changes back to memory transmission mode.
Auto
Auto
Auto
Fax
Internet Fax
Scan:
Scan
Send:
Standard
Auto Reception
Fax Memory:100%
8½x11
File
Quick File
Address Review
Direct TX
Sub Address
Address Book
Special Modes
Resolution
Exposure
Original
USB Mem. Scan
Data Entry
(3)
(1)
(2)
Fax/Original
OK
Auto
Auto 8½x11
Scan Size
2-Sided
Tablet
2-Sided
Booklet
Send Size
100%
Image Orientation
(2)
(1)