Sharp MX-M850 - Manual (Page 644)

74
Administrator Adjustment
"Administrator Adjustment" is a special adjustment function for the administrator. This lets the administrator correct the
position and size of images and perform fine adjustment of the output positions of peripheral devices.
Image Adjustment
Fine-adjustment of devices related to the image can be performed.
Edge Adjustment
This adjusts the position of the leading edge of the
scanned or printed image (the position where the image
begins).
Copy Edge Adjustment (Original Edge Standard
Position)
This adjusts the position of the leading edge of the
original for copying.
Set a number from 10 to 99 (1 = 0.1 mm). A higher
number will cause a greater delay in the timing of
recognition of the leading edge of the original, moving
the leading edge of the scanned image in the direction
opposite to the direction of original feeding.
Copy Adjustment (Registration Motor ON Timing)
This adjusts the leading edge of the printed image by
adjusting the response speed of the resist roller (the
roller that adjusts the printing position on the paper being
fed).
Set a number from 1 to 99 (1 = 0.1 mm). A higher
number will move the leading edge of the printed image
in the direction opposite to the direction of paper feeding.
Separate settings can be specified for the feeder and
auto duplex unit (ADU).
SPF Original Edge Adjustment (Original Scan Start
Position)
This adjusts the position of the leading edge when an
original is scanned using the automatic document
feeder.
Set a number from 1 to 99 (1 = 0.1 mm). A higher
number will cause scanning of the original to start later,
moving the leading edge of the scanned image in the
direction opposite to the direction of paper feeding. (On
the reverse side, the leading edge of the scanned image
will move in the direction of paper feeding.) Separate
settings can be specified for the front and reverse sides.
Off-Center Adjustment
Image off-center adjustment can be performed.
Print Off-Center Adjustment
This adjusts the center of the printed image in each tray
and in the auto duplex unit (ADU).
Set a number from 1 to 99 (1 = 0.1 mm). A higher
number moves the image toward the back of the
machine.
Original Off-Center Adjustment
This adjusts the center of original scanning on the
document glass and in the automatic document feeder.
Set a number from 15 to 85 (1 = 0.1 mm). A higher
number moves the image toward the front of the
machine.
Adjustment is performed at the factory prior to shipment, and thus the initial values of the settings will vary on each unit.
Increase the
adjustment value
Image
Increase the
adjustment value
Image