Kathrein UFS 822sw - Manual (Page 10)

10
CONNECTION AND SET-UP
To enable you to utilise all the reception and recording properties of your UFS 822 twin-PVR Sat receiver,
such as
1. recording one programme and at the same time viewing any other programme or zapping through the
channels, and
2. recording two different programmes at the same time,
the two tuner inputs of the Sat receiver must each be supplied with a dedicated satellite signal from the
antenna system/Sat outlet.
The receiver tuner inputs are factory preset on the installation menu to work with two separate Sat antenna
connections.
If you only have one antenna connection available, we recommend you interconnect the output of tuner 1
and the input of tuner 2 using the loop-through cable supplied.
For this, in “First Installation” for tuner input 2 select “Loop-through mode” (see “First Installation” section).
Press the

button to access the “Tuner Input” menu option, then choose “Installation” and “First
Installation”. Go through step-by-step until you get to Tuner Setup, you can make the settings here,
though a restriction on this is that with tuner 2 you can only receive the additional channels of the plane
currently set by tuner 1 (e.g. Horizontal High).
Loop-through cable
INFORMATION ABOUT ANTENNA CONNECTION AND “LOOP THROUGH”
OPERATION
If you wish to operate
your UFS 822 on a single-
cable system, please
refer to the connection
example for single-
cable systems (see
“Connection Examples”)