Kathrein UFS 822sw - Manual (Page 11)

11
If only tuner 1 is connected (with no connection to tuner 2), the “Single Mode” setting must be selected
for the tuner input. You then have only the facilities of a normal “single receiver” available to you.
If this setting is not made, malfunctions will occur and the following message will be displayed:
No signal!
CONNECTION AND SET-UP
Connect the satellite receiver (TV Scart socket) and the TV set using a Scart cable (see “Connection
Example”). If your TV has a stereo capability, you can receive the sound in stereo via the Scart connection.
Connect the satellite receiver (VCR/AUX Scart socket) and the video recorder/PVR likewise by a Scart
cable. For system reasons, the same video signals are to be found on the Scart outputs and on the video
cinch output.
If you want to play the sound on your hi-fi system, connect the audio cinch sockets to the input sockets on
the hi-fi system with an appropriate cable (see “Connection Example”).
The fi bre-optic output is intended for the connection of a Dolby Digital system (see “Connection Example”).
TV AND VIDEO RECORDER CONNECTION
AUDIO CONNECTION
OPTICAL DIGITAL OUTPUT
This will only work when receiving one satellite, not in multi-feed reception!
If you are recording using an external video recorder, remember not to operate the
receiver during recording, otherwise all the on-screen displays will appear on your
recording.
To access the menu for the setting “Single Mode”, proceed as follows:
Main menu
→ Installation → Antenna settings → Connection type