Kathrein UFS 822sw - Manual (Page 55)

55
On this menu you can make settings for your recordings and for timeshifting.
PVR SETUP
Use the

buttons to select whether automatic timeshifting is enabled or disabled. When you select
“On” the receiver automatically (in the background) starts recording the programme you are viewing as
soon as you switch to the channel. Then, in manual record mode, you can press the

(red) button
to choose whether to record the programme from the current time or from the time you switched to the
channel. The advantage of this is that you do not lose the part of the programme you were watching
before you decided to record it! When you select “Off” you can only record the programme as from the
point you press Record, and lose the portion of the programme before you started recording.
AUTOMATIC TIMESHIFT
USER PREFERENCES
Use the

buttons to select whether hard disk management is controlled by the receiver “Automatic”
or by you “Manual”.
If you select “Automatic”, the receiver automatically deletes older recordings when it reaches the
maximum disk capacity, so as to make room for planned recordings. (You can, however, protect
recordings from being deleted by the receiver, as described in the “Recording List” section under
“Edit Recordings” - “Deletion Block”.)
If you select “Manual” you must always ensure there is suffi cient hard disk capacity yourself. If the available
disk capacity falls below fi ve percent, a warning appears the next time you restart the unit.
DISK MANAGEMENT
Use the

buttons here to select the size of the background buffer the receiver makes available for
timeshift recording. You can choose between 1 and 8 GB, in 1 GB increments. The receiver indicates in
brackets after the GB fi gure how long this will enable it to background-record for.
TIMESHIFT BUFFER SIZE