Kathrein UFS 822sw - Manual (Page 16)

16
Use the
 
buttons here to select the settings for your TV set.
Refer to the operating instructions for your television set!
Video Output
Here select the type of video signal at the Scart socket or HDMI socket. Select the signal that your TV set
can process.
- FBAS – composite colour baseband signal
(colour/picture/blanking/synchronisation
signal)
- RGB – Red/Green/Blue signal
- Y/C – S-Video signal (luminance/chrominance) or
- YUV – component data
TV Type
Here select the TV's picture format. Either
- 4:3 format,
- 16:9 format or
- HDMI
Display Format
Select the screen display mode here:
- for TV type “4:3”: “Pan & Scan” or “Letter-Box”
- for TV type “16:9”: “Automatic” or “Always 16:9”
- for TV type “HDMI”: “Automatic” or “Always 16:9”
Rear fan
Here you can select whether the rear fan always runs whilst the unit is switched on “On” or whether the fan
will be switched on and off again at pre-programmed intervals “Scheduled”.
Press the
!
(green) button to move to the next menu.
FIRST INSTALLATION
The following display appears:
If during the First
installation it is
detected that
an HDMI device
is connected,
“HDMI” is automatically pre-
selected as the TV type.