Kathrein UFS 822sw - Manual (Page 22)

22
Single-cable system
“Automatic”
Single-cable system
“Manual”
Press the
!
(green) button to continue with the installation.
Display of the valid single-cable frequencies found
by the receiver (example):
Single-cable frequency 0–1400 MHz
Single-cable frequency 1–1516 MHz
Single-cable frequency 2–1632 MHz
Single-cable frequency 3–1748 MHz
The number of searches is limited to 10. If the
tenth search is performed and still no success, the
system switches to manual mode. It can however
be switched back into automatic mode.
Press the
 
buttons to set the two
single-cable frequencies to be used by your
receiver.
Then press the
!
(green) button to obtain the next
screen.
FIRST INSTALLATION
Note: If there already is a UFS 822 on the
system and a second UFS 822 is to be added,
the fi rst UFS 822 should be switched on and both
tuners should be active, so that the single-cable
frequencies for the fi rst receiver remain reserved.
The two receivers cannot share the same
frequencies. Note: If there already is a UFS 822 on the system
and a second UFS 822 is to be added, you
must assign different frequencies to the second
UFS 822 (otherwise the receivers will interfere with
each other).
A maximum of two UFS 822 receivers can be
connected to a 4-SCR system.