Kathrein UFS 822sw - Manual (Page 120)

120
INSTALLATION MENU
Network Search:
Use the

buttons to select the setting for the network search.
If you set the network scan to “On”, the transponder network enables additional transponders that have
not yet been stored to be located. They are then stored and searched for new channels in the same
way as the existing transponders.
If you set the network search to “Off”, only the factory stored transponders of the satellites you previously
selected will be scanned for new as yet unlisted channels.
FTA CA Select:
Use the

buttons to select whether you want to search through all channels or only
FTA (Free to Air) or CA (Conditional Access) channels (Common Interface “encrypted channels”).
Start Search:
When you have made your selection, use the

buttons to select “Start Search” and press
the button to start the search.
ADVANCED CHANNEL SEARCH
Transponder Frequency:
Use the numeric pad on your remote control to key in the frequency of the transponder on which the
channel you are searching for is located.
Transponder Polarisation:
Use the

buttons to select the polarisation of the desired transponder here.
Symbol Rate:
Use the numeric pad on your remote control to key in the symbol rate of the transponder here.