Kathrein UFS 822sw - Manual (Page 17)

17
FIRST INSTALLATION
Note: If you are unsure whether
you chose the right
option from a previous
menu, you can go back
a step at any time during
the First installation
process by pressing
the (red) button.
Press the

buttons here to select the connection type and signal confi guration for the tuners set on
the receiver by you or the engineer.
You have the following options:
Installed system
- “LNB/DiSEqC™ System”: Conventional satellite reception (simple digital satellite system)
- “Single-cable system”: Satellite reception using a “single-cable system” (functions at present only using
a single cable system from Kathrein!)
Connection type for tuner 2
- “Separated”: Tuner 2 (input) has its own signal input, i.e. a direct connection between the antenna socket
and the tuner 2 input
- “Loop-through”: The signal currently connected to the tuner 1 loop-through output is looped-through to
tuner 2 (input). Refer also to the section headed “Operation on one Antenna Connection”
Signal confi guration for tuner 2 (only in “Separated” connection type)
- As for tuner 1: Both tuners are connected to the same signal source (same cable from LNB)
- Different from tuner 1: The two tuners are connected to different signal sources (separate cables
from LNB)
Press the
!
(green) button to move to the next menu. The notes on the subsequent First Installation
menus are divided into two columns. The left-hand column indicates the further installation
procedure for the “Same with tuner 1”, signal confi guration, while the right-hand column details the
“Different to tuner 1” procedure. If your reception system is a “Single-cable” system from Kathrein,
continue the First installation as described on page 25.
The satellites shown in the following screenshots are factory preset. To be able to
receive the satellites you want, your system must be aligned to them!
The following display appears: