Kodak 9500 - Manual (Page 105)

A-61092 September 1999 8-39
Before you begin Before feeding documents containing patches, verify the following:
•
The Patch Reader is properly positioned.
•
Patch reading is enabled.
•
End-fed patch reading is enabled (if desired).
•
The patch code confirmation tone is enabled (if desired).
Positioning the
Patch Reader There are five locations for the Patch Reader.
NOTE: If patch reading is performed by a Document Scanning Array,
the following instructions do not apply.
Using the Patch Reader The Patch Reader may be installed to read patches placed on the front
of the documents being processed.
Patch Reader
locations
Patch Reader
To move the Patch Reader:
1. Lift the Patch Reader out of the current location and place it in the
desired location.
2. Be sure the patch placed on the document and the position of the
Patch Reader are aligned so the patch will be read properly.