Kodak 9500 - Manual (Page 76)

8-8 A-61092 September 1999
Enabling bar
code reading Make sure that Bar Code Reading is enabled before feeding
documents.
To enable Bar Code Reading at the mode level:
•
Enter function code F60.
Partial Bar Code Reading allows the scanner to read bar codes with a
start character (and
n characters beyond the start character that can be
read) even if no end character is encountered.
To enable Partial Bar Code Reading:
•
Enter function code F66.
NOTE: Partial Bar Code Reading can only be enabled (or disabled) if
Bar Code Reading is enabled at the mode level.
If you have enabled the Bar Code Reader, but do not want to
read/decode bar code(s) found on the next document only, perform
function code F64.
Enabling the bar
code confirma-
tion tone The bar code confirmation tone may be used to signal that a bar code
has been read.
•
If your scanner is configured for no confirmation tones, then no
confirmation tones of any kind will be heard in any mode.
•
If your scanner is configured to allow confirmation tones, then you
can disable (or enable) confirmation tones in any mode as desired.
If the confirmation tones and the bar code confirmation tone are
enabled during installation for the mode being used, you may
enable/disable the bar code confirmation tone during normal
operations by performing function code F63.
In addition, a bar code/patch confirmation tone may be used to signal
that both a bar code and a patch have been detected. This
confirmation tone may be enabled or disabled by performing function
code F62.
NOTE: Patch Code Reading must be enabled in the scanner in order
to use this feature.