Kodak 9500 - Manual (Page 50)

A-61092 September 1999 5-15
Replacing the imaging
guides To replace the imaging guides, follow the steps below:
1. Open the right-side access door.
2. Locate and grasp the end of the upper imaging guide. Carefully
slide the imaging guide out of its track.
IMPORTANT: Use care when handling the imaging guides. Hold
the imaging guides by the green handles only.
3. Locate and grasp the end of the lower imaging guide. Carefully
slide the imaging guide out of its track.
4. Grasp and hold the new lower imaging guide by the green handle
and carefully slide it into place. Make sure the grooves fully engage
the track.
5. Grasp and hold the new upper imaging guide by the green handle
and carefully slide it into place. Make sure the grooves fully engage
the track.
NOTE: The imaging guides are not interchangeable. They can
only be inserted one way.
6. Close the right-side access door.