Kodak 9500 - Manual (Page 62)

A-61092 September 1999 7-1
7 Troubleshooting
Trouble and remedy
chart
This chapter outlines some of the problems you may encounter and
their probable causes and remedies.
Trouble Probable Cause Remedy
Scanner does not power on
(status display does not
illuminate). The power cord is not
connected. Push the power cord plug into the
receptacle.
The wall outlet is defective. Check the outlet (call an
authorized electrician.)
The main power switch is off. Turn the main power switch on.
The side panel switch is off. Turn the side panel switch on.
The cabinet covers are not
closed. Check and close all the cabinet
covers.
Documents not feeding
properly. The feed and separator roller
gap is not properly adjusted. Refer to Chapter 2, “Adjusting the
feed and separator roller gap”.
Feeding thick documents
without using the gap release
lever. Refer to Chapter 2, “Adjusting the
feed and separator roller gap”.
The feed and separator rollers
may be dirty. Refer to Chapter 5, “Cleaning the
feed and separator rollers”.
The feed shelf position is not
properly adjusted. Refer to Chapter 2, “Adjusting the
feed shelf position”.
The feed shelf side guides are
not properly adjusted. Refer to Chapter 2, “Adjusting the
feed shelf side guides and end
stop”.
Documents not stacking
properly. The exit hopper side guides are
not properly adjusted. Refer to Chapter 2, “Adjusting the
exit hopper side guides and end
stop”.
The exit hopper end stop is not
properly adjusted. Refer to Chapter 2, “Adjusting the
exit hopper side guides and end
stop”.
The wrong deflector is being
used. Refer to Chapter 2, “Changing the
deflector.”