Kodak 9500 - Manual (Page 97)

A-61092 September 1999 8-29
Changing the ink
roller Feed several blank pages to ensure that the print quality is
acceptable. If the endorsements are light or hard to read, you may
need to replace the ink roller.
NOTE: Before replacing the ink roller, place a protective cover over the
work surface near your machine. This protects your work
surface from ink stains when you remove the old ink roller.
To change an ink roller:
1. Open the top cover.
2. Open the new ink roller container and remove the plastic gloves. Use
the plastic gloves to keep your hands clean when handling the inked
rollers.
3. Open the cover plate covering the ink roller and slide out the roller
carrier holder.
4. Carefully remove the ink roller by lowering it and removing it from the
retaining slots. Use the paper to roll it up. Place it in a container and
discard it.
5. Use your gloved hand to unwrap the new ink roller and install it into
the roller carrier holder. Make sure the roller snaps into the retaining
slots.
6. Open the cover plate and slide the roller carrier holder back into its
original position, making sure it is fully seated.
7. Close the top cover.
Cover plate
Ink roller
Roller carrier
holder