Kodak 9500 - Manual (Page 18)

A-61092 September 1999 2-7
Adjusting the feed
shelf side guides
(semi-automatic feeder
only)
Before you begin processing documents, adjust the side guides on the
feed shelf to accommodate the documents being processed.
1. Slide apart the side guides on the feed shelf until the feed shelf
label is visible.
Feed shelf label
Side guide
Side guide
Feed shelf
Feed Shelf Label
Center line
2. Center the documents across the feed shelf label. Adjust the feeder
side guides dependent upon the width of the document. Leave
approximately 1/16 in. (2 mm) clearance on each side of the
documents so they feed properly.
NOTE: If the documents are larger than the area shown on the
feed shelf label and do not fit between the side guides,
rotate and reposition the documents within the side guides.