Kodak 9500 - Manual (Page 67)

7-6 A-61092 September 1999
The lower roller
assembly area To clear the lower roller assembly area (Area C):
1. Open the top cover.
2. Open the right-side access door.
Vertical baffle
handle
Lower roller
assembly
Baffle plate
3. Remove the imaging guides (not shown in this illustration).
IMPORTANT: Use care when handling the imaging guides. Hold
the imaging guides by the green handles only.
4. Turn the vertical baffle handle latch counterclockwise to unlatch the
baffle plate. Lower the baffle plate until it stops. This unlocks the
lower roller assembly.
5. Grasp the lower roller assembly handle (as shown) and slide the
assembly toward the rear of the machine.
6. Remove any documents or document pieces.
IMPORTANT: Do not slide the lower roller assembly back into place
without first removing the imaging guides. Failure to
remove them first can cause misalignment and/or
damage to the machine.
7. Slide the lower roller assembly back into place.
8. Raise the plate into its original position. Turn the vertical baffle latch
clockwise to lock the baffle plate into position. Be sure the baffle
plate is securely locked into its original position.
9. Replace the imaging guides.
10. Close the right-side access door and top cover.