Kodak 9500 - Manual (Page 96)

8-28 A-61092 September 1999
7. Remove the rubber die by carefully prying it off. Insert a new rubber
die in place of the old one. Ensure that it engages the spring clips at
both sides. (If an entire die drum assembly is available to replace the
die, this is not necessary.)
8. Reinstall the die drum assembly by inserting the shaft, aligning the
die, and directing the shaft into the mounting holes and the slot.
9. Raise the drum locking lever to secure the die drum assembly.
10. Rotate the Endorser toward the front of the unit. The latch will
automatically lock the Endorser in place.
11. Lift the locking lever to secure the Endorser.
12. Close the top cover.
13. Feed several blank pages to allow the new die to be properly inked.
Die
Spring clip
(Pry off at this edge)