Kodak 9500 - Manual (Page 86)

8-18 A-61092 September 1999
Using the
Display option The Display option allows you to display the decoded value of an
individual bar code as it is fed into the transport. After selecting Option
2, DISPLAY, feed a bar code document.
To verify that a bar code is decoded properly:
1. Select 2=DISPLAY.
Bar Code Type =
1=EVALUATE 2=DISPLAY 3=%KODAK 4=%NORM
One of the following messages will be displayed:
•
Bar code was not read.
If the display indicates the bar code was not read, it could be for
one of the following reasons:
◊
The type of bar code read was not the type indicated in the
status display.
Action: Verify the type of bar code read.
◊
The bar code quality is poor.
Action: Perform the required maintenance.
•
?
This display indicates the start character was recognized, but the
remainder of the bar code was unreadable.
Action: Perform the required maintenance.
•
Decoded bar code value
This display gives the decoded value of the bar code read.
2. When the test is completed, press C to return to normal operation, or
press Stop to remain in the test environment.
Using the %KODAK
option The %KODAK test option establishes the percentage of bar codes
properly read when using Kodak Bar Code Standard Test Documents.
This option is designed to provide a baseline value as well as the
current read rate. A comparison of the two values provides a measure
of machine performance over time.
To use the %KODAK test option:
1. Select 3=%KODAK.
Bar Code Type =
1=EVALUATE 2=DISPLAY 3=%KODAK 4=%NORM
2. Feed at least 100 Kodak test documents. As documents are fed into
the transport, the Kodak documents fed value will increment.
Kodak documents fed = 100
Current = xx.x%
Historical = xx.x%