Kodak 9500 - Manual (Page 24)

3-4 A-61092 September 1999
Feeding thick
documents
The gap release lever is used to feed thick documents such as card
stock or cover stock. The lever is located on the front panel of the
scanner, next to the gap adjustment knob.
(Graphic depicts movement
of separator rollers when
lever is used)
Gap
release
lever
(Graphic depicts gap
adjustment)
1. Press down and hold the gap release lever. This opens the gap
between the feed and separator rollers, allowing thick documents to
pass between them. You will be able to see the gap open as the
lever is pushed down.
2. Insert the thick document past the rollers until it is taken into the
transport system.
NOTE: If more than one thick document is to be scanned, feed
them into the transport one at a time.
Gap release
lever
(hold down) Feed roller
Gap
Separator
roller
Thick
document
3. After the thick document(s) have been scanned, release the gap
release lever; it will return to its original position. The feed and
separator rollers will return to their previously adjusted positions.