Kodak 9500 - Manual (Page 25)

A-61092 September 1999 3-5
Feeding documents
using the automatic
feeder
Following are document feeding instructions using the automatic
feeder. After the scanner has been prepared for operation, the desired
mode and any temporary operating values have been defined, you are
ready to feed documents into the transport.
1. Verify that the power is on and that any adjustments have been
made (feeder side guides, exit hopper side guides, etc.).
2. Select a stack of documents that is no more than 1.5 in. (38 mm)
thick. Hold the stack with the front sides facing up and the top of the
documents facing toward the scanner. Tap the top edge of the stack
against a flat surface so the documents are in an even bundle.
3. Fan the stack of documents so the leading edge of the top
document sticks out the farthest.
4. Lift the feeder module up and slide the leading edge of the
document underneath the feeder module. To help prevent multiple
feeds, place the stack of documents under the feeder module and
pull the stack back slightly (about ¼-inch) from the separator roller.
5. Press Run.
NOTE: Be sure the documents are center-fed so each document
covers the 3 ½-inch required width.
6. As you scan documents, set the image level, as required, and
periodically remove documents from the exit hopper.
7. Repeat Steps 2 through 4 until all of the application documents
have been fed into the transport.
8. Press Stop after all documents have been deposited in the exit
hopper.