Adjusting the feed and separator roller gap – Kodak 9500 User Manual
Page 15
2-4
A-61092 September 1999
Adjusting the feed
and separator roller
gap
(semi-automatic
feeder only)
IMPORTANT:
Before adjusting the feed and separator roller gap, be
sure the feed and separator rollers are clean. Cleaning
the feed and separator rollers will frequently resolve
document feeding problems.
The adjustment procedure should only be done when
feeding and separating problems continue after the feed
and separator rollers have been cleaned. For
procedures on cleaning rollers, see Chapter 5,
Maintenance.
The gap adjustment knob on the control panel increases or decreases
the space between the feed and separator rollers. The gap must be
adjusted properly for smooth transportation of documents without
document overlap.
When documents of different thicknesses are fed in a group, adjust the
gap using the thinnest document in the group.
The feed and separator roller gap may have to be adjusted to
compensate for:
•
Very thin documents (onion skin, tracing paper, etc.).
•
Very thick documents (card stock, punch cards, cover stock).
•
Some coated documents (photographic paper, plastic-coated
paper).
If the gap is not adjusted properly:
•
More than one document at a time may be drawn into the transport
system at the same time; not all of the documents will be scanned.
•
Documents may be drawn into the transport too quickly; documents
may overlap or be spaced too closely (causing an error display).
•
Documents may become skewed during transport; jamming may
occur.
NOTE: Prior to performing the adjustment procedure, the scanner
must be calibrated and enabled.
To adjust the feed and separator roller gap:
1. Turn on the side panel switch.
2. Enter function code F04 and enable Counting Only.
3. Press
Enter.
4. Press
Run.
IMPORTANT:
Do not make a gap adjustment while documents are
in the feeder or transport system; doing so will
produce an inaccurate adjustment.
5. Turn the gap adjustment knob clockwise three complete turns, or
until it stops, to open the gap between the feed and separator
rollers.