Konica Minolta C250P - Manual (Page 189)

Specifying printer driver settings 3
C250P 3-56
Center Binding
You can specify to center staple and fold a printed document.
1
Click the Layout tab.
2
From the “Center Staple and Fold” drop-down list, select “Center Sta-
ple and Fold”.
3
To avoid printing on the folded part of the document, select the “Center
Erase” check box.
2
Note
“Center Staple and Fold” cannot be specified if “Staple” or “Punch” has
been selected.
“Center Staple and Fold” is available if optional finisher FS-603 or if sad-
dle stitcher SD-503 is installed on optional finisher FS-514 is installed.
“Center Erase” is available only if finisher FS-603 is installed.
The available center binding and folding settings differ depending on the
finisher that is installed. When FS-514 is installed, in addition to “Fold &
Staple” (which folds the documents in half before stapling them), “Center
Staple” (which binds documents with staples at the center) and “Fold”
(which folds documents in half) are available. When FS-603 is installed,
only “Center Staple and Fold” is available.
Hole punching
Holes can be punched into the printed document.
1
Click the Layout tab.
2
From the drop-down list, select whether two or three holes are to be
punched.
2
Note
The hole punch function is available only when optional finisher FS-603
and punch kit PK-501 are installed or when optional finisher FS-514 and
punch kit PK-510 are installed.