Konica Minolta C250P - Manual (Page 70)

Setting up the printer driver 2
C250P 2-7
Automatic installation using the installer
With the installer, this machine is detected to determine whether it is con-
nected by USB or is on the same TCP/IP network as the computer, and then
the required printer is automatically installed. You can also manually specify
the printer driver to be installed.
!
Detail
Since this machine is automatically detected with a network connection,
be sure to set the IP address of this machine before connecting it. For the
setting procedure, refer to “Specifying the TCP/IP settings” on
page 2-37.
For IPP printing, it is not necessary to install the printer driver at this time
since IPP printing setup is performed when the printer driver is installed.
For further details on IPP printing, refer to “IPP printing (Windows 2000/
XP/Server 2003)” on page 2-50.
2
Note
When installing the printer driver on a computer running Windows NT 4.0,
Windows 2000, Windows XP, or Windows Server 2003, Administrator
privileges are required.
In order to install this machine on a network with a direct connection us-
ing the TCP/IP protocol, Microsoft TCP/IP must first be installed on the
computer being used if it is running Windows NT 4.0.
If the wizard starts up in order to add new hardware with a USB or parallel
connection, click [Cancel].
Installer operating environment
-
Operating System: Windows 98SE, Windows Me, Windows NT 4.0 (Serv-
ice Pack 6a or later), Windows 2000 Professional (Service Pack 4 or later),
Windows XP Home Edition (Service Pack 2 or later), Windows XP Profes-
sional (Service Pack 2 or later) or Windows Server 2003
- Processor: Pentium 300 MHz or higher recommended
- Memory: 64 MB or more (128 MB or more recommended)