Konica Minolta C250P - Manual (Page 62)

Installation and operation precautions 1
C250P 1-43
1.8 Connecting to a computer
Compatible interfaces
The various interfaces that can be used to connect this printer to a computer
are described below.
Ethernet interface
Connect when using this printing system as a network printer.
Supports 10Base-T and 100Base-TX standards. In addition, the Ethernet in-
terface supports the TCP/IP (LDP/LPR, peer-to-peer), IPX/SPX (NetWare),
and AppleTalk (EtherTalk) protocols.
Parallel interface (optional)
Connect when using this printing system as a local printer.
A computer running Windows and an IEEE 1284 parallel cable are required
for connection. Use a parallel cable that uses a terminal with an Amphenol
36-pin male connector.
The parallel interface supports the compatible, nibble, and ECP modes.
USB interface (optional)
Connect when using this printing system as a USB printer.
The USB interface can be connected to a computer running Windows. A
USB cable is required for connection. Use a type A (4 pin, male) or type B (4
pin, male) USB cable. A USB cable measuring 3 meters or less is recom-
mended.
2
Note
The USB and parallel interfaces cannot be used as the same time.
Change the setting in the “I/F Setting” menu of the “Admin. Setting”
menu.