Konica Minolta C250P - Manual (Page 359)

Maintenance 7
C250P 7-6
Emptying the waste containers
If the hole-punch waste container in punch kit installed on Finisher FS-603
becomes full, the message shown below appears (if it can be emptied by the
user).
2
Note
When the message “Punch Scrap Full Call Service.” appears, contact the
service representative.
The setting for the message contents for emptying the hole-punch waste
container must be specified by the service representative. For details,
contact the service representative.
!
Detail
If the hole-punch waste container becomes full, printing cannot be per-
formed with a Punch setting. To continue printing, empty the hole-punch
waste container or cancel the Punch setting.