Kodak 800 SERIES User Manual
Page 163
Troubleshooting
4-64
NovaJet 800 Series Service Manual
Figure 4-67. Cartridge Identification Chip.
3.
It is possible the ID chip on the rear of the cartridge may have
slipped from its original position. Verify the double dimples (2
small circles on flex cable) have been penetrated at or near the
center of each circle. If not the chip is out of position or is not
mating correctly within the carriage assembly. After correcting,
reattach cartridge, message should clear automatically after
selecting OK.
4.
To clear the error, turn the printer off and then on again. Press
Utility Menu/Service Menu/Cartridge Info to determine the cartridge
for which the error message is displayed. The incorrectly
registered cartridge will have two asterisks (*) displayed. Press
Utility Menu/Access Menu/Access Right to move the carriage
assembly to the service position to allow replacement of the
appropriate ink cartridge. Check to make sure you have the
correct cartridge for your printer model installed in each position.
Install new cartridges if necessary.
5.
Reseat both large flat white trailing cables at the Main circuit
board if the above steps do not work. Reseat both cables at the
carriage PWA’s. Reseat all flex driver cables at rear side of
carriage PWA’s.