Kodak 800 SERIES - Manual (Page 235)

NovaJet 800 Series Service Manual
Assembly\Disassembly 5-31
22. Turn the Belt Removal Tool to tighten the belt around the Servo Motor
pulley.
23. Move the Carriage Assembly back and forth to check the Carriage Belt
tension. Remove the Belt Removal Tool.
24. Gently move the Carriage Assembly from end to end and make sure
that the Carriage Belt is not binding
25. Install the Ink Delivery System following procedures outlined earlier in
this chapter.
26. Install the Top, Left and Right Covers following procedures outlined
earlier in this chapter.
Remove the Carriage PWA
CAUTION
Integrated circuits may become weakened or damaged by
electrical discharge. Do not touch or work near integrated
circuits without wearing an ESD wrist strap.
1. Remove the Top, Left and Right Covers following procedures outlined
earlier in this chapter.
2. Remove the Ink Delivery System and the Carriage Assembly following
procedures outlined earlier in this chapter to remove the Carriage
Assembly from the Slide Shaft.
3. Put on an ESD wrist strap.
4. Unlock the connectors and remove all flex cables on the Carriage
PWA.