Kodak 800 SERIES - Manual (Page 205)

5
5-1
Assembly\Disassembly
Introduction
Chapter 5 contains the procedures for removal and replacement of the
NovaJet 800 series printer assemblies and mechanisms. Illustrations are
provided for clarity. Steps for each replaceable part may depend on parts
already removed in previous disassembly directions. It is recommended
that you read through each procedure before beginning the removal and
replacement of any assemblies or mechanisms.
The following tools are recommended to disassemble and reassemble the
printer:
•
#1 Phillips Torque Screwdriver
•
#2 Phillips Torque Screwdriver
•
#1 Slotted Torque Screwdriver
•
#2 Slotted Torque Screwdriver
•
#1 Phillips Screwdriver
•
#2 Phillips Screwdriver
•
#1 Slotted Screwdriver
•
#2 Slotted Screwdriver
•
Wrench, 1/4”
•
Screwdriver, Socket Head, 1/4”
•
Wire Cutters
•
Needle Nose Pliers
•
X-ACTO Knife
•
ESD Wrist Strap
The following materials are also required:
•
Isopropyl Alcohol
•
Cotton Swabs
•
Lint Free Cloth or Tissue
•
Double Sided Tape (1/16” thick, 3/4” wide)
•
Loctite Blackmax, P/N 200172