Remove the service station – Kodak 800 SERIES User Manual
Page 244
Assembly\Disassembly 5-40
NovaJet 800 Series Service Manual
TABS
Figure 5-25. Carriage Bushing Installation.
6.
Orient the new bushing as shown in Figure 5-25 so that the metal tab
on top of the bushing goes into the Carriage Assembly first.
7.
Push the bushings in until they snap into place.
8.
Install the Carriage Assembly and Ink Delivery System following
procedures outlined earlier in this chapter.
9.
Install the Top, Left and Right Covers following procedures outlined
earlier in this chapter.
Remove the Service Station
SERVICE
STATION
RELEASE
TAB
Figure 5-26. Service Station Removal.
1.
Place the Top Cover in the open position.
2.
Move the Carriage Assembly to the left side of the Slide Shaft.
3.
Reach into the Right Cover and pull back on the Service Station
release tab located on the far side of the Service Station. See Figure
5-26.
4.
Raise the right side of the Service Station out of the Platen.