Kodak 800 SERIES - Manual (Page 77)

Maintenance 3-25
NovaJet 800 Series Service Manual
MAINTENANCE
Calibration Jo Block (1.434”) - Not used
Plastic Gauge Card (0.011”) - Not used
There are two basic measurements that are to be made using this kit (ensure power
is off prior to performing these proceures):
1. Slide Shaft Profile Adjustment
2. Carriage (Cartridge) Head Height Setting
1. Connect the dial gauge micrometer to the Shaft mounting block as shown in
Figure 3-11.
ZERO
GAUGE
SHAFT
MOUNTING
BLOCK
TIGHTEN SET
SCREW (NOT
SHOWN)
Figure 3-11. Dial Gauge Micrometer Assembly.
2. Place gauge against left side of shaft assembly allowing micrometer tip to
rest directly on top of shaft. See Figure 3-12. Zero the gauge (this is to
become the reference point).