Kodak 800 SERIES - Manual (Page 253)

NovaJet 800 Series Service Manual
Assembly\Disassembly 5-49
3. Remove the Service Station following procedures outlined earlier in this
chapter.
CAUTION
Be careful when removing any foam blocks so that it does
not tear. It is very important to have an intact foam block
to produce sufficient vacuum inside the Platen. This is re-
quired to properly hold the media down onto the Platen.
4. Using the access gained by removing the Right Sideplate and the
Service Station, remove the right foam block from between the Lower
Drive Roller Assembly and the Servo Motor.
5. Remove the Ink Delivery System following procedures outlined earlier
in this chapter.
6. Remove the Left Assembly following procedures outlined earlier in this
chapter.
NOTE
The 42 inch model has one Vacuum Fan and Exhaust as-
sembly while the 60 inch model has two sets of Vacuum
Fans and Exhausts.
7. Remove the four (eight) screws on the bottom of the Platen which hold
the Fan Exhaust(s) in place.
8. While holding the Vacuum Fan through the hole where the Exhaust
assembly was, remove the 3 screws on the bottom of the Platen that
secure the Vacuum Fan(s) . Do not allow the screws to come out at
an angle.
9. Remove the Platen Plug from under the Platen.
10. Remove the black flat-head screws from the top of the Platen that
holds the Center Support in place. Remove the Center Support through
the Platen Plug hole.