Kodak 800 SERIES - Manual (Page 255)

NovaJet 800 Series Service Manual
Assembly\Disassembly 5-51
13. Remove the Stepper Motor Extension Spring from the Stepper Motor
and the post on the Left Lower Drive Shaft Bracket. See Figure 5-30.
ATTACH SPRING
TO POST
ON BRACKET
Figure 5-30. Stepper Motor Removal/Installation.
14. Remove the hardware securing the Stepper Motor to the Left Lower
Drive Shaft Bracket and remove the Stepper Motor.
Install the Lower Roller Assembly, Stepper Motor and Vacuum Fan
(NovaJet 850)
1. Loosely attach the Stepper Motor to the Lower Roller bracket using
Stepper Motor hardware as shown in Figure 5-30.
2. Attach the Stepper Motor tension spring to the Stepper Motor and the
Lower Roller Bracket. Tighten the Stepper Motor hardware to 8 in-lb of
torque.
CAUTION
It may be necessary to loosen (do not remove) the screws
that secure the Y-Arm Assembly to the Platen so that the
Lower Drive Roller Assembly clears the ends of the screws