Kodak 800 SERIES - Manual (Page 268)

NovaJet 800 Series Service Manual
Assembly\Disassembly 5-64
NOTE
Some units may have very small servicing loops in the wir-
ing of the Dryer Assembly. When removing the Right
Endcap, the possibility exists that a connection may have
been pulled loose elsewhere within the body of the dryer if
extreme force is used to pull the endcap away from the
main body. During assembly, ensure that all internal con-
nections are good, including connections located at the left
side of the dryer.
5. Disconnect the ground connection from the power cord to the main
body of Thermal Dryer.
6. Disconnect all other connections going from the main body to the
printed wiring assembly.
Install the Thermal Dryer Right Endcap Assembly
NOTE
Some of the units may have very small servicing loops in
the wiring of the Dryer Assembly. When removing the Right
Endcap, the possibility exists that a connection may have
been pulled loose elsewhere within the body of the dryer if
extreme force is used to pull the endcap away from the
main body. During assembly, ensure that all internal con-
nections are good, including connections located at the left
side of the dryer.
1. Reconnect all the connections going from the main body to the printed
wiring assembly on the Right Endcap Assembly. See Figure 5-36 and
Table 5-1.