Remove the stabilizer bracket and encoder strip – Kodak 800 SERIES User Manual
Page 247
NovaJet 800 Series Service Manual
Assembly\Disassembly
5-43
6.
Reposition the Floating Carriage Cover/Right Support Bracket
Assembly and the Left Support Bracket around the Carriage
Assembly. Secure the Left Support Bracket to the Floating Carriage
Assembly. Torque to 15 in-lbs.
7.
Install the Top and Right Covers following procedures outlined earlier
in this chapter.
Remove the Stabilizer Bracket and Encoder Strip
1.
Remove the Top, Left and Right Covers following procedures outlined
earlier in this chapter.
2.
Remove the Ink Delivery System, Carriage Assembly and Trailing
Cable Assembly following procedures outlined earlier in this chapter.
3.
Remove the Chain Support Bracket by slightly tilting the top of the
Chain Support Bracket towards the front of the printer and lifting it
straight up. See Figure 5-27.
CHAIN SUPPORT
BRACKET RESTS
ON THE TOP
OF THE Y-ARM
ASSEMBLY
Figure 5-27. Stabilizer Bracket Installation/Removal.