Kodak 800 SERIES - Manual (Page 230)

Assembly\Disassembly 5-26
NovaJet 800 Series Service Manual
LATCH
Figure 5-16. Strain Relief Removal/Installation.
9. Slide the Carriage Assembly to the left edge of the Slide Shaft while
taking up the slack of the Belt at the same time.
NOTE
The Belt is connected to the right Carriage only. The left
Carriage is directly connected to the right Carriage. The
left Carriage moves with the right Carriage, which is driven
by the Belt.
10. Slide the Carriage Assembly slowly off the left side of the Slide Shaft
until the left Carriage slides off of the Slide Shaft and disconnects itself
from the right Carriage. Place the left Carriage aside.
11. Slide the right Carriage and Drive Belt off the left side of the Slide
Shaft.
12. Once the right Carriage is removed from the Slide Shaft, turn it over so
that you can see the Belt Clamp. See Figure 5-17.