Liebert 130 kVA - Manual (Page 15)

User Manual
Hipulse - Single Phase ‘1+N’ UPS System 130 kVA - 110V
1 General Introduction 1
1.1 Introduction 1
1.2 Design Concept 1
1.2.1 Hipulse Module Design 1
1.2.2 Bypass Supplies 2
1.2.3 System control Philosophy 3
1.2.4 ECOMODE (for single UPS) 4
1.2.5 UPS Power Switch Configuration 5
1.2.6 Battery circuit breaker 5
1.2.7 Battery temperature compensation 5
1.2.8 System Expansion 5
2 Installation Procedure 7
2.1 Introduction 7
2.2 Environmental Considerations 8
2.2.1 UPS location 8
2.2.2 Battery Location 8
2.3 Mechanical Considerations 9
2.3.1 System composition 9
2.3.2 Moving the cabinets 9
2.3.3 Clearances 9
2.3.4 Fixing Magnetic Components 9
2.3.5 Cable entry 9
2.4 Preliminary Checks 10
2.5 Installation Drawings 10
3 Installation (Electrical) 13
3.1 Power Cabling 13
3.1.1 System Configuration 13
3.1.2 Cable rating 14
3.1.3 General Notes 14
3.1.4 Cable connections 14
3.1.5 Safety earth 14
3.1.6 Protective Devices 15
3.1.7 Cabling procedure 16
3.2 Control cables 19
3.2.1 Battery Control 19
3.2.2 Auxiliary Terminal Block X3 and X4 at UPS 20
3.2.3 Emergency Stop 21
3.2.4 Back feed Protection 21
4 Operator Control and Display 23
4.1 Introduction 23
4.1.1 Operator Control Panel 24
4.1.2 The Menu Options 27
I N D E X