Liebert 130 kVA - Manual (Page 43)

User Manual
Hipulse - Single Phase ‘1+N’ UPS System 130 kVA - 110V
23
CHAPTER 4
Operator Control and Display Panel
4.1 Introduction
On the front of the UPS there is a display and control panel, from which it is possible to
easily verify the status of the UPS included all the measured parameters and alarms of
the UPS and Battery. The operator control panel is divided into three functional areas:
‘Mimic LED display’ and Inverter Control switch,
‘Operator Panel’ and ‘LCD display’,
‘Bargraph section’.
As can be seen the left section consists of LEDs which indicate the operational and
alarm status of the system by turning ON or OFF or by flashing ON/ OFF.
The middle section of the operator control and display panel consists of a LCD (Liquid
Crystal Display) and its associated switches.
The following functional area (right section) shows the various UPS load and Battery
charging conditions.
Fig 4-1: UPS Operator Control / Display Panel
ESC
MENU
ENTER INV
%
HIPULSE