Panasonic 524X07801B - Manual (Page 140)

140 DBS 576 (USA), Revised 6/11/98 576-13-700
Chapter 5. Key Telephone Features Section 700 - Operation
To outdial from the Call Log:
To store the Call Log number in a personal speed dial:
Hardware Requirements
• Caller ID daughter circuit card on the Loop Start Trunk Card if a Loop Start Trunk receives the
call.
• ISDN (PRI-T Point) if ISDN card receives the call.
• Large Display Telephone or 44-Series Small Display Telephone.
Action Result
1. Go off-hook or press On/Off. Intercom dial tone
2. Dial the Call Log feature code (default = CONF 96). Phone enters call log mode.
3. Press the following keys to view the call log:
# - Move forward in call log
* - Move back in call log
NEXT - View the next 5 calls
PREV - View the previous 5 calls
4. To return a call, (and exit the Call Log)
Press the Soft key to the left of the desired number to
access Access MCO 1 (dial “9”), dial add digits (usu-
ally
“1” ), and dial the displayed caller ID #
or
Press the Soft key to the right of the desired number to
access MCO 1 (dial “9”), and dial the caller ID #
Action Result
1. Go off-hook or press On/Off. Intercom dial tone
2. Dial the Call Log feature code (default = CONF 96). Phone enters call log mode.
3. Press the following keys to view the call log:
# - Move forward in call log
* - Move back in call log
NEXT - View the next 5 calls
PREV - View the previous 5 calls
4. To store the call log number in a personal speed dial:
Press PROG, the speed dial bin number (80 - 99) and
press the left Soft key (to dial the add digits,usually an
area code) and HOLD
or
Press PROG, the speed dial bin number (80 - 99) and
press the right Soft key and press HOLD