Panasonic 524X07801B - Manual (Page 65)

Section 700 - Operation Chapter 3. System Features
576-13-700 DBS 576 (USA), Revised 6/11/98 65
CO line No. (CO line No.: 1 to 576 / When CO line is disconnected while the call is on hold:
*1 to *576)
Dialed No. (24 digits max. including 0-9, *, # Cannot display Flash or Pause. If a number is
hidden, * will appear instead of digits. * will stay with the call even if the call is transferred.
For Format 2, an I Proceeds the digits if it is an incoming call.)
Accounting code (10 digits max.)
Verified Account code (Verified Account code table number V001 to V500)
Caller data (Format #2 only)
ISDN charge data (Format #2 only - originator number applies to ISDN only)
H Carriage return line feed
Related Programming
• FF2: SMDR for Outbound Calls (for Analog, E&M Tie Line, and ISDN)
• FF2: SMDR for Inbound Calls (for Analog, E&M Tie Line, and ISDN)
• FF1-006: Serial Port Receive Data
• FF1-009: SMDR Output Format
Hardware Requirements
• A printer or external call accounting system is required to receive SMDR data.
Considerations
• A call must be answered to generate SMDR data (e.g., answered by Voicemail, call pickup, etc.)
• You can specify which type of SMDR data format is sent (i.e., either Format 1 or 2).
Toll Restriction Service
Description
Toll Restriction Service (TRS) allows access levels, including the prohibition of long distance calls or
after-hours calls, to be assigned to specific extensions or CO lines. This minimizes non-business
related calls and reduces phone bills by only allowing long distance calls over designated lines.
TRS can be used in conjunction with Automatic Route Selection (ARS).
• TRS classes are set on an extension and trunk basis. Up to 50 TRS classes can be assigned.
• Each TRS class is then assigned to a TRS level. This level is used as the basis for allowing or
restricting calls.
• There are 10 TRS levels available: 0 denies all calls, 1-8 may be partially restrictive per
assignments, and 9 allows all calls.
• TRS can restrict the number of digits dialed (1 to 20 digits limit or no limit).
• TRS can restrict the use of System Speed Dials (SSDs) for out dialing on a TRS class basis;
either no system speed dials or limit the range of SSDs.
5
6
7
8
9
10