Panasonic 524X07801B - Manual (Page 69)

Section 700 - Operation Chapter 3. System Features
576-13-700 DBS 576 (USA), Revised 6/11/98 69
Operation
To set a Call Forward ID Code for Voice Mail:
To clear the ID Code:
Hardware Requirements
• N/A
Related Programming
• N/A
Considerations
• N/A
DID/DNIS/DDI Voice Mail ID Code
DID/DNIS/DDI calls may be sent directly to voice mail through the used of the DID Voice Mail ID
Code. A prefix and suffix may be specified to be sent to the voice mail as well as a chosen number of
DID digits.
Either no digits (default), the last two digits of the DID, the last three digits of the DID or the entire
DID number may be sent.
The prefix may be up to eight digits including 0-9, *, # and pause (REDIAL).
The suffix may be up to eight digits including 0-9, *, # and pause (REDIAL).
Hardware Requirements
• N/A
Action Result
1. Go offhook or press ON/OFF key.
2. Dial the Call Forward ID Code (default = 715). Enter V.M. ID displays
3. Enter the ID code required by voice mail (see your voice
mail manual). Usually this is the extension number.
4. Press the HOLD key. Stored V.M. ID displays
5. Go onhook or press ON/OFF key.
Action Result
1. Go offhook or press ON/OFF key.
2. Dial the Call Forward ID Code (default = 715) Enter V.M. ID displays
3. Press the HOLD key. Cleared V.M. ID displays
4. Go onhook or press ON/OFF key.