Panasonic 524X07801B - Manual (Page 154)

154 DBS 576 (USA), Revised 6/11/98 576-13-700
Chapter 5. Key Telephone Features Section 700 - Operation
Considerations
• If a new code is programmed into a key, the previously programmed code is erased.
• FF keys assigned as CO lines must be cleared using system programming before new FF
assignments can be made.
• The System can be programmed so that MCO 1 Trunk Access calls automatically use Automatic
Route Selection (ARS).
• The ANSWER key functions as listed in the table below.
• The RELEASE key functions as listed in the table below.
•
Table 13. Feature access codes for FF key assignments
Status Condition Operation when ANSWER key is pressed
Idle No incoming ring Ignore.
Incoming ring Monitor ON (speaker) - Auto Answer for incoming ring.
Off-Hook Off-hook signaling Answer for off-hook signaling. Current conversation will be
put on hold automatically.
No off-hook signaling Ignore.
NOTE: When the extension has 1 non-appearing CO on hold and 1 non-appearing CO at talk, ANSWER key oper-
ation is ignored and you can’t put the 2nd non-appearing CO on hold.
Status Condition Operation when RELEASE key is pressed
Idle -- Ignore.
Monitor ON (speaker)
or Headset Mode Several held calls Latest held call will be transferred; phone returns to idle sta-
tus (Monitor OFF).
No held calls Current call (talk) will be released; phone returns to idle sta-
tus (Monitor OFF).
Handset Off-Hook Several held calls Latest held call will be transferred; phone gets internal dial
tone.
No held calls Current call (talk) will be released; phone gets internal dial
tone.
Feature Description
Fixed Feature Code
+ (additional digits to program into
key)
Default Flexible Feature Code
(if not listed, must use Fixed Feature
Code)
CO Trunk Key # + (Trunk 1-576)
MCO Key
1 + (Auto-Select Pattern 1-5;
MCO-Incoming Trk Grp 00-99)
Virtual Port Key
∗
9 + (Virtual Port 001-576)
BLF/DSS Outgoing 9 + (Extension 0-9999)
BLF/DSS Immediate Ring 81 + (Extension 0-9999)
BLF Delayed Ring 82 + (Extension 0-9999)