Panasonic 524X07801B - Manual (Page 28)

28 DBS 576 (USA), Revised 6/11/98 576-13-700
Chapter 3. System Features Section 700 - Operation
Considerations
• N/A
Caller ID
Description
A properly equipped DBS 576 supports Caller ID, a service offered by the network telephone
service provider. The CO sends calling number information to the DBS 576 after the first
ring. Users who have display telephones can see Caller ID information as incoming calls ring
at their extension and can have access to previous calls via the Caller ID Call Log feature.
The Caller ID number is recorded in SMDR.
Hardware Requirements
• Loop-start trunk card (VB-44510)
• Caller ID circuit card (VB-44513)
Related Programming
• FF2-0: Caller ID
• FF2-0: Caller ID Ring Control
• FF3-0: Call Duration Display
Considerations
• ISDN (PRI - T Point) can get calling party information.
• Caller ID service must be ordered from the local telephone operating company or the
interexchange carrier.
• Caller ID data is usually sent between the first and the second rings of the incoming trunk call.
The trunk may be programmed to immediately ring at the station or wait until after the Caller ID
digits are received before ringing at the station. If the trunk is programmed to ring immediately,
the Caller ID digits will not display until after they are received and processed.
• Caller ID numbers may be denied from being sent for some callers (private). Some long distance
carriers may not provide Caller ID data (out of area).
• Caller ID only support the single format (number only). Multiple format (number and name) is
not supported.
Centrex/PBX Compatibility
Description
Centrex/PBX Compatibility allows the System to be connected behind centrex or PBX lines.
The System supports up to 6 access codes for dialing centrex or a PBX. These access codes allow the
System, System Message Detail Recording (SMDR) output to exclude the number dialed to reach a
centrex or PBX line.