Panasonic 524X07801B - Manual (Page 172)

172 DBS 576 (USA), Revised 6/11/98 576-13-700
Chapter 5. Key Telephone Features Section 700 - Operation
To answer an OHVA:
To transfer a call using OHVA:
3. Enter the OHVA feature access code (default = 8). • OHVA EXT XXX displays if busy
extension called (where XXX = calling
extension.
• EXT LED flashes
4. Make your announcement
Action Result
1. Press the OHVA Split key.
Note: You must program an FF key as a split key (default =
*71) to use this feature.
Split key flashes red
2. To return to the previous call, press the Split key again. The OHVA originating party receives
Busy signal.
Action Result
1. Press the HOLD key to put the current call on hold. Current call on hold
2. Dial the extension number to which the call is being trans-
ferred.
Busy signal
3. Enter OHVA feature access code (default = 8) and announce
the call to be transferred.
4. If transfer is:
• Not accepted, retrieve the call by pressing the associ-
ated flashing MCO key (if an appearing call) or by
pressing the HOLD key (if a non appearing call).
• Accepted, and On-hook Transfer is enabled for your
extension, replace the handset or press the ON/OFF
key.
If On-hook Transfer is not enabled for your extension,
press the PROG key (or RELEASE key if using DSS/
72).
Action Result