Chapter 2 installing hardware and software 31 – Perle Systems RIO 5500036-17 User Manual
Page 10
RIO Remote I/O System User Guide
Page 10
Before you start ...............................................................................................33
Downloading RIO drivers from the Perle web site ...................................34
Installing RIO under Solaris ..........................................................................35
General setup procedure for Solaris .........................................................36
Upgrading from existing device drivers.....................................................38
Upgrading your current RIO driver............................................................38
Installing device drivers and utilities..........................................................39
Assigning ISA host card addresses and IRQ levels..................................41
Removing RIO drivers and utilities from your system ...............................42
Setting up terminals using Admintool........................................................44
Removing RIO serial port terminals ..........................................................49
Updating your RIO system configuration ..................................................51
Installing RIO under SCO OpenServer 5 and SCO OpenServer 6 .........52
General installation procedure for SCO OpenServer 5 and SCO OpenServer 6
53
Installing device drivers and utilities..........................................................54
Removing device drivers and utilities from your system ...........................62
Configuring ports with config.rio................................................................64
Adding an RTA to the system....................................................................65
Removing an RTA from the system ..........................................................69
Creating a login for an RTA.......................................................................72
Installing RIO under SCO UnixWare ............................................................76
General installation procedure for SCO UnixWare ...................................77
Installing device drivers and utilities..........................................................78
Assigning ISA host card address and IRQ levels .....................................79
Configuring ports with config.rio................................................................82
Adding an RTA to the system....................................................................83
Removing an RTA from the system ..........................................................86
Removing device drivers and utilities from your system ...........................89
Creating a login for an RTA.......................................................................89