Perle Systems RIO 5500036-17 - Manual (Page 173)

RIO Remote I/O System User Guide
Removing a Remote Terminal Adaptor (RTA)
Page 173
Chapter 2 Installing hardware and software
Removing a Remote Terminal Adaptor (RTA)
To remove an RTA from your RIO system proceed as follows;
1. Turn off the power to the RTA you want to remove and disconnect the power lead from
the unit
2. Disconnect the link cables from the unit
3. Disconnect any peripheral cables from the unit, for example printer, terminal and so on.
4. Update to your system for the revised configuration. The exact procedure for this will
depend on the operating system, see the following for details;
Operating system For updating the system, see
Solaris Updating your RIO system configuration on page 51 .
SCO UnixWare Removing an RTA from the system on page 86 .