Perle Systems RIO 5500036-17 - Manual (Page 102)

RIO Remote I/O System User Guide
Installing RIO under Windows NT
Page 102
Chapter 2 Installing hardware and software
Introduction
Once you have installed your RIO system under Windows NT, you can view changes to your
RIO system using the RIO Configuration utility.The map(s) of the system displayed in the
RIO Configuration utility will respond automatically to changes to your RIO system.
Note
When the RIO Configuration utility is not running, The RIO software will store any changes to
your system and will update the display when you next run the RIO Configuration utility.
Note
In the event of link failure or disconnection, the broken link will disappear from the system
map displayed in the RIO Configuration window and any isolated RTAs on the system map
now appear greyed out.
As soon as the link is restored, the map is updated automatically to display the new or
resumed link. (RIO will remember the configuration of your RTA(s). There is no need to
reconfigure the unit(s).