Perle Systems RIO 5500036-17 - Manual (Page 101)

RIO Remote I/O System User Guide
Installing RIO under Windows NT
Page 101
Chapter 2 Installing hardware and software
Making and displaying changes to your system configuration
This section describes how to make and view changes made to your system following initial
configuration under Windows NT using the RIO configuration utility.
The following sections are provided;
• Introduction on page 102
• Displaying multiple networks on page 103
• Printing a copy of the system map on page 103
• Identifying an RTA on page 104
• Displaying a port configuration summary on page 105
• Adding a Fault Tolerant Link on page 106
• Adding an RTA to your system configuration on page 106
• Adopting Port Names on page 107
• Moving an RTA on page 108
• Removing an RTA on page 108
• Disconnecting an RTA from within the software on page 108
• Re-booting an RTA on page 109
• Adding a Host Card on page 109
• Removing a Host Card on page 109
• Manually loading the module and firmware on page 150