Performing the send data to port test, Performing, The send data to port test – Perle Systems RIO 5500036-17 User Manual
Page 295
RIO Remote I/O System User Guide
SCO UnixWare troubleshooting
Page 295
Performing the send data to port test
To run the Send data to port test proceed as follows;
1. In the tty menu, click on
and press the
Enter
key.
The Online Diagnostics menu is now displayed as shown in the next picture.
2. In the Online Diagnostics menu, click on
Send data to port
.
A test parameters window is now displayed which allows to set the values required for the
duration of the test.
3. In the test parameters window, use the cursor keys to select the value you want to set
then cycle through to the value you want using the space bar key.
Note
Before you can perform this test, you need to select the RTA and port you want using
the procedures given in
Selecting the RTA and port to test
.